2. speakers
  3. 1040658046

Will cheater rob my PC's?

My REL Storm is dead quiet when connected to my Berning ZH-270 amp, but exhibits a low-level hum when connected to my new Art Audio Diavolo amp. Other than amps, all connections are the same. The REL is plugged into a different outlet than the rest of the equipment, but that's out of necessity due to location and lack of additional outlets. And as I mentioned, it's perfectly behaved with the Berning.

I've tried a cheater plug on the REL to no avail. The amps are connected to a PS Audio Ultimate Outlet which has had it's outgoing ground wire disconnected, so in essense, the amps have had their grounds lifted. The remainder of the equipment is connected to a PS Audio PS300, which is grounded.

I'm getting ready to try connecting cheater plugs to all the equipment with the exception of the preamp. But I'm concerned about the negative effect this will have on all my expensive power cords connected to this equipment.

Wouldn't the cheap cheater plug wipe out all the benefits of having a high end PC?

Any and all opinions are welcome.
kenl

Showing 3 responses by kenl

kenl OP
131 posts
 
Warrenh,

Thanks for the suggestions. I'll give them a try and see if that sheds any light on the problem.

Snook2

Makes you wonder if we really hear the differences we claim when we first install the $1,200 cord, doesn't it? Like you, I would expect it to make an audible difference. . .for the worse. I may try it just to see.
kenl OP
131 posts
 
Islandflyfisher:

Like you, I'm operating 2 amps. The Diavolo is for 2-ch and the fronts of my HT, while an EAD PM 2000 handles the remaining HT channels. Both amp's power cords are connected to a PS Audio Ultimate Outlet that has had it's ground wire disconnected on the outlet end. It's still connected at the wall end. I was told by PS Audio that this way I have lifted the ground to the equipment, but the UO still is grounded to the wall, thus keeping it's surge protection intact.

If this is so, then in essence I've already lifted the grounds to both amps. Still a slight hum remains.

Sugarbrie:

I had the same problem with the REL when I was just running the EAD amp. On it was OK. With the amp off, the REL would hum. My current problem is it hums regardless of the amp being on or off.

I will contact Sumiko and see if they have a fix. I'll let you guys know what they have to say. In the meantime, have a great Holiday Season! Thanks for your help.
kenl OP
131 posts
 
Came up with a simple fix. I disconnected the REL's yellow ground wire from the amp's positive terminal on the left binding post and wrapped it around one of the amp's screws on the chassis. Instant silence.

It may not be the most elegant solution, but with the amp in my rack the wire's unobtrusive, and it works. Sometimes the best solutions are also the simplest. Thanks to all for their help and suggestions.

Happy Holidays!!
More to discover