Why not get a meter and measure the actual value of caps from both crossover and go from there?
Why are my crossovers different
So the schematic on my m1 crossovers says that c2 circuit (midrange circuit) should total 26.7uF
The crossover that I just recapped had the c2 circuit at 25.7uF.
The crossover I’m working on right now has the c2 circcuit at 28.1.
It does not appear these have not been tampered with since the factory.
So the question is should I make the second c2 circuit match the 25.7 of the first or should I put it back the way it was at 28.1
I could make the second one a 26. 8uF. I accidentally damaged a 1.3uF that was in the 28.1. So I’m debating on whether I should replace it or leave it out.
Your input would be appreciated
The crossover that I just recapped had the c2 circuit at 25.7uF.
The crossover I’m working on right now has the c2 circcuit at 28.1.
It does not appear these have not been tampered with since the factory.
So the question is should I make the second c2 circuit match the 25.7 of the first or should I put it back the way it was at 28.1
I could make the second one a 26. 8uF. I accidentally damaged a 1.3uF that was in the 28.1. So I’m debating on whether I should replace it or leave it out.
Your input would be appreciated