Make sure the tubes are all seated correctly, you might have to wiggle them a bit in their sockets until you're getting both channels. 6SN7s, I have three of them, may light up very faintly, and in a lighted room you can just barely see they're on.
What's a properly lit 6SN7 tube look like?
I just purchased an SET 300B amp here on the 'Gon, and after a bit of light cleaning of pins and sockets, etc; I fired it up.
All the tubes light up, but the single 6SN7 tube only lights at the top, while the 6BX7's light top and bottom. I get no sound out of the amp, with the exception of a very weak sound (music from the source) in the R/channel, with the preamp turned all the way up.
Any help would be greatly appreciated!
Thanks,
Dan
All the tubes light up, but the single 6SN7 tube only lights at the top, while the 6BX7's light top and bottom. I get no sound out of the amp, with the exception of a very weak sound (music from the source) in the R/channel, with the preamp turned all the way up.
Any help would be greatly appreciated!
Thanks,
Dan