2. amps-preamps
  3. 1267619266

What is a good upgrade for a Nuforce Icon?

I have Monitor Audio BR2 speakers which are 6ohm and the recommended wattage is 30-100 watts. As of now I am using the Nuforce Icon which is 12 watts per channel. I was using it as a dac and an amp. I am about to get a separate dac and was looking to upgrade the icon.

My room is L shaped 3meters wide where the speakers are and about 6 meters long. My couch is 3.5 meters from my speakers.

My question is would there be a big difference with an amp that outputs in the 30 to 100 range? What are good amps that would sound better than the icon for $300 or less?

I am living in Japan so some of the brands I hear about are not sold here.

I am looking forward to hearing everyone's suggestions.
graben

Showing 1 response by sfar

sfar's avatar
sfar
1,756 posts
 
This doesn't answer your question (does any question ever get directly answered on audiogon?) but I also have an Nuforce Icon and am now using it as a DAC and preamp driving a tube amp.

I wanted to try tubes in my office system with a pair of JohnBlue JB3 speakers so I bought one of the new Jolida FX10 EL84 integrated amps and am driving it from the line-out jack of the Icon, essentially using the Jolida as a power amp rather than an integrated.

It's a very nice combination, much more organic and realistic than the Icon by itself, and with better bass, but preserving the ability to connect my MacBook to the Icon's DAC through USB. I like it a lot.

It's a much bigger improvement than was adding a Valab DAC to the system to bypass the DAC in the Icon.
More to discover