2. analog
  3. 1269119805

want new plinth ideas for direct-drive turntables


By now, the idler-drive genre has enough ink on them without me adding anything new to the topic. What is little talked about is the "guts" of direct-drive tables. Many vintage DD units suffered from bad plinth design with inadequate solidity (often mounted to crappy plastic or flimsy particle-board) and inadequate isolation from resonance and interference of electronics.

I like the bare bone approach, that is, to take the motor out of the chassis/plinth/enclosure and mount it to a something solid, material of your own choice, and extend the cable by at least couple feet to the stock chassis or an enclosure that contains the electronics/motor-drive/control-console/power-supply. In fact, the Monaco Grand-Prix, Teres Certus, or early Micro-Seiki DDX/DQX-1000 takes the same approach.

Almost ALL DD tables can be improved this way. There are many other brands of superb DD tables with great potential out there can be had for very reasonable price and can be converted this way with good result. I no longer have any Technics tables on hand to experiment but I still got great results with some mid-priced JVC, Pioneer, Kenwood, Yamaha, etc... I haven't tried it on Sony and Denon tables yet because they require mounted a tapehead to check platter speed so the mounting is tricky. Modern belt-drive turntables have been doing similar things by separating the motor from the main plinth. Once again, Micro-Seiki was ahead of their time with their RX-1500 and beyond. It's only logical DD will go that direction. The days of having everything in a box for DD tables seems less attractive to me now.

If you have other ideas, feel free to talk about it here. And hopefully this will generate more new interest in the DD genre. Personally I am more interested in people's experience with brands other than Technics as they already got enough coverage in other forums and threads. Nothing against Technics, just want to direct attention to other sleepers out there. Anyway, still feel free to share ideas.

_________
hiho

Showing 1 response by pryso

pryso
1,909 posts
 
Need some 'splainin' here, as Desi Arnaz used to say.

I don't know all that much about electronics and I'm only familiar with the SP-10 Mk 2 series of DD tables. But since the motor must remain attached to the spindle and platter, how much benefit can be gained by moving the circuit boards outboard? It seems to me the biggest potential problem could come from the current field of the motor itself, rather than the circuit board(s). For this reason the addition of an EMF/FRI shield such as recommended for the Kenwood L-07D, suggested by T_bone above, and implemented by Albert Porter in his SP-10 tables, would be as good an upgrade and far simpler and cheaper.

Concerning Dertonarm's suggestion for suspension to isolate outside vibrations, would not the high torque motor of the better DD tables be the largest source for micro-vibrations in most set ups? How would suspension address that?

Thanks for any more light on these thoughts.
More to discover