2. analog
  3. 1363574460

VPI Classic motor question

I have a Classic with the 600 RPM motor. The table is 2.5 yrs old. The motor started making a swooshing sound on each rotation about a year ago which continued after lubricating it. The sound could only be heard with the ear to the pulley and the speed stability seemed fine with the SDS. I lubricated the motor again about two weeks ago, including removing the pulley and cleaning the shaft, and the swoosh continued. Today I started hearing a more frequent noise that sounds like a very low friction sound. Still very low, but what the hell?

Is there is anything I can do about it at this point? I don't think putting more oil into the motor after I just lubricated it will fix it. If the speed appears to be ok, should I just ignore it? The first time I heard the noise VPI did not offer any advice beyond lubricating the motor. Is replacing the motor the only way to take care of the problem perhaps?

Any advice and feedback would be appreciated.
actusreus

Showing 1 response by sarcher30

sarcher30
596 posts
 
Should be easy to change the motor. First unplug the power supply then remove the belt, platter, and arm wand. Then turn it on it's side and remove the metal plate under the motor. The wires are not soldered. They just use wire nuts. It should be easy to figure out what wires come from the motor. Once you figure that out disconnect them and mark them with tape if need be. Then remove the screws that hold the motor in and remove the motor. Pop in the new motor which hopefully has the same colored wires and reverse the process. You could also take a picture of the wiring before disassembling it so you don't forget how it went. It is really pretty simple wiring so that is not really necessary.

Hopefully they will send instructions with the motor. If your still uncomfortable messing with it I'm sure they can do it for you if you send it back to them.

More to discover