Upgrading Spikes on Target Wall Shelf

Thanks guys! I'm using a slate replacement board because it has been identified by the importer of my TT as the best solution for this particular piece of equipment. He has experimented with many materials.

I don't like the rounded screws either but I still want the re-leveling capability for the shelf.

Wait a second...what if I keep the screws and srew on to them audio points. In terms of vibration control, would it be a no-no for the points to point up with the slate board sitting ontop?

Thanks Stan, I've noticed a number of isolation products using some sort of ball.

It's very difficult to level the Target frame because the one I got is not perfectly true. There is also a degree of flexing depending upon the amount of weight applied. I also don't want to use the feet of my turntable for leveling. I wish to tighten them up and then loosen each one slightly. This leaves the leveling to the slate shelf.

I'm not using the Star Points but have some solid brass ones from way back when. This solution turned out to be very good looking if nothing else. It just seems to me that I'm sending vibration from top and bottom into the slate.