TOTEM Sttaf removing mass loading


I am considering the purchase of a totem sttaf. They have been loaded with kitty litter by the owner. The owner says this makes shipping difficult, and even if removed there could be problems caused by left over kitty litter moving around in there. This worries me, I would like to be able to remove all of it and have an unbiased speaker. Does anyone have experience with removing mass loading from a Totem Sttaf speaker? Please explain how to remove mass loading. Please also explain if you believe that if you remove the mass it is safe to ship. Thanks.
dfelkai

Showing 1 response by meerzistar

A few specs of residual kitty litter doesn’t weigh much, I would not worry about it. As long as there sealed up appropriately.

"totem also recommended ’beaks’...yeah, right."

The beaks can make a dramatic difference. I hung around while a friend tuned his sttaf’s long after they endured plenty of break in time. Then beaks were installed. Unlike a lot of flashy gimmicks they are one of those things that just work. After beaks were installed they were partially loaded with Sudbury nickel.

dfelkai I recommend trying both, beaks and mass. Run them bare until you get accustomed to them, then do a before and after. Don’t fill them up at one go. Gradually load, test, repeat. When you pass an obvious sweet spot remove a little. Weighing each time you add makes it easy.