Swap out 12bz7 in favor of 12ax7?


I've asked this question before, but maybe wasn't specific enough so I thought I'd try again. I have a Cary V12r amp which has two 12bz7 tubes in the signal path. I understand that the 12bz7's are a high-gain alternate to the 12ax7. The question is, in this amplifier, could I take out the 12bz7 tubes and replace them with the lower gain 12ax7 tubes? I know a fair number of A-Goners have switched from the 12ax7 to the 12BZ7 for the added gain but I'm looking for the the opposite. Any thoughts?
grimace

Showing 1 response by andyz

I have not tried the 12ax7 tubes, but you can do it. I also have a V12R and have just installed nos 12bz7's. The amp responds well to changes to these and the el84's, as well as the power tubes. I just spoke with Mark at Cary and he suggests keeping the 12bz7 for the sound and that they are generally less expensive. As you probably know, the amps "R" status is based on the 12bz7 upgrade from the 6922 predecessor V12 amps, and the 450 volt transformers, up from the previous 375 volts. I am curious to hear any difference between the 2 different tubes if you do give it a try.
One other nice option with the V12 architecture is running it with only 4 power tubes. I have some matched quads, el34, 6L6, 6550 and KT77's which I have been able to roll around without spending several thousands of dollars for 12 tubes. Plus, it doesn't heat the house as much now that it is summer. In the winter though, it runs all 12 Tungsol 6550's and it thumps in triode mode.
Have you tried to under-bias the amp (10%-20%)? You may get the effect you are looking for.
Good luck and keep me posted. You have a fantastic amp!