Interesting you should bring that up Zerofox. I contacted Wilson about the resistor issue I started this thread on and received this response:
Truthfully, the most challenging aspect of the resistor change is removing the access door - after years of high tension from the screws, the gasket can get quite sticky and it can feel like it is glued in place. The key is to remove all of the screws and walk away for an hour while the gasket starts to breath and open up….some have had to use a bit of heat from a hair dryer and I usually have to insert two Allen wrench drivers to gently pry the plate off and then you can insert the tools just inside the screw hole opening and apply downward pressure. The plate should pry free.