Mark, just went to your system page, good looking system by the way but I have a question for you. In the description of your table you make reference to the 10 inch arm doesn't sound much different from the 9 inch arm it replaced, my question is, did you use the same mounting/arm board and set up jig that you used for the 9 inch arm? This might be the reason for the 5 mm difference in your ps2 measurement. Enjoy the music
Pivot to Spindle distance
My P2S distance is off by about 5 mm (over). But my cartridge seams to be aligned pretty good. Is there any advantage to having the P2S distance exact? Sounds spectacular with my redoing the entire setup.
Must have had a senior moment during the P2S alignment part.
VPI Aries
JMW-10 arm
VPI jig (to get it close)
WallyTractor (final alignment)
Must have had a senior moment during the P2S alignment part.
VPI Aries
JMW-10 arm
VPI jig (to get it close)
WallyTractor (final alignment)