I'm trying the Nobsounds under my preamps right now. First, I got the cheaper plastic ones to try because the aluminum ones were not available. I had to use two springs per corner and wrap the springs with Teflon tape to stop the squeaking. They worked but the resonance point was 8 Hz. I just got the aluminum ones a few days ago. They are much nicer. I found that I could use just one spring per corner now and got the resonance down to 4 Hz. They are effective isolators. With one spring per corner I have roughly 0.200" gap or travel left. The springs in the nobsounds will not deform if you go closed coil and since this is a static application working height/load is not an issue. Just maintain some clearance or they cannot isolate. I believe the ideal resonance is 3 Hz for the most effective isolation.
Nobsound springs - load range
I want to try out the Nobsound springs as damping footers (mainly under my mono blocks and my streamer). I ordered a first set of them and now I wonder about the amount of springs to put in for different weights of equipment.I remember one post that said it works best when 50% compressed (was it @millercarbon?).
I measured the compression of the springs, it takes ~2.5 kg per spring to compress it to 50%. Based on 50% compression target, this yields the following sweet spot configurations (only stable ones, total equipment weight):
- 3 units, 3 springs each: 22.5 kg
- 4 units, 3 springs each (or 3 units, 4 springs each): 30 kg - 4 units, 4 springs each: 40 kg
- 3 units, 6 springs each: 45 kg
- 3 units, 7 springs each: 52.5 kg
- 4 units, 6 springs each: 60 kg
- 4 units, 7 springs each: 70 kgLoad can be considerably higher than expected (somewhere I read about 36kg, which is presumably for 4 units).
Any comments?What about ~10 kg streamer, seems to be too light to compress the springs enough? Does anyone have experience with Nobsound springs under light equipment like this?
Based on your experiences: Would you even dare to put an 80kg floor standing speaker on Nobsound springs?
I measured the compression of the springs, it takes ~2.5 kg per spring to compress it to 50%. Based on 50% compression target, this yields the following sweet spot configurations (only stable ones, total equipment weight):
- 3 units, 3 springs each: 22.5 kg
- 4 units, 3 springs each (or 3 units, 4 springs each): 30 kg - 4 units, 4 springs each: 40 kg
- 3 units, 6 springs each: 45 kg
- 3 units, 7 springs each: 52.5 kg
- 4 units, 6 springs each: 60 kg
- 4 units, 7 springs each: 70 kgLoad can be considerably higher than expected (somewhere I read about 36kg, which is presumably for 4 units).
Any comments?What about ~10 kg streamer, seems to be too light to compress the springs enough? Does anyone have experience with Nobsound springs under light equipment like this?
Based on your experiences: Would you even dare to put an 80kg floor standing speaker on Nobsound springs?