2. analog
  3. 1188511434

MMF 2.1 azimuth/tonearm lifter problem

I recently purchased a used Music Hall MMF 2.1 and have no experience setting up turntables. I followed the manual instructions with success except for one problem. The cartridge (Goldring Elan) was not even with the groove (the left side was higher). I adjusted this by loosening the ultra-small screw on the back of the tonearm and leveling the tonearm to make the cartridge even. In doing so, I made it so the tonearm lifter pin did not reach the rear of the tonearm to lift the stylus off the record. The lifter did work prior to the adjustment due to being lower on one end, and hence, closer to the lifter pin. My questions are as follows:
1) Should I not have adjusted the azimuth?
2) Are certain cartridges supposed to be uneven?
3) Should I not worry about using the tonearm lifter?
4) DO cartridge heights vary? (I am considering a AT 4470Mla)

Any assistance will be greatly appreciated.

Johnny
johnnypeepers

Showing 3 responses by armstrod

armstrod
601 posts
 
1) You adjusted VTA (vertical tracking angle), not azimuth. Azimuth is not adjustable on the MMF2.1.

2) VTA is different for every cartridge. Adjusting to parallel to the record, as you did, is a good place to start. Do a search and you'll come up with multiple threads on adjusting VTA.

3) The tonearm lifter (cueing) isn't required but it sure is handy and safer than manual cueing. IIRC, there's an adjusting screw for the height of the cueing platform. If not, a small piece of foam attached to the platform would work.

4) Cartridge heights definitely vary. VTA will need to be adjusted again if you change cartridges.

David
armstrod
601 posts
 
My mistake - what you did is definitely azimuth - they must have added that adjustment since I owned my MMF 2.1. Given that, what I don't understand is how adjusting the azimuth could change the cueing level. I suppose having azimuth dead straight could have raised the arm a bit, but not by much.

Did you check to see whether the cueing platform has an adjustment? Most do, but I'm not sure I ever checked on mine since it always worked. Adding a pad to the cueing platform may be the easiest way to go.

David
armstrod
601 posts
 
Johnnypeepers

Now I remember - the cueing platform on the MMF 2.1 tonearm is actually attached to the tonearm. I had to put a pad on top off the cueing piston ("bolt") to keep the arm from being pulled sideways by the antiskate when the arm was lowered. I just Blu-Tak'ed a felt pad on there, but if you need something thicker, you could use foam or rubber.

You've done exactly right by setting the azimuth perpendicular and the arm parallel to the record - that's always a good starting point. Your cueing problem is the manufacturer's fault - they haven't given you a way to adjust it. You'll just have to perform a slight mod on your own.

David
More to discover