tablejockey
This is where the groove will be if it's the same system https://ibb.co/3hWRVTQ This is the Theos
Cheers George
Showing 2 responses by georgehifi
tablejockey I don’t know about your model. But the three models I had which were bigger even bigger again and biggest, you pressed from behind the "back" center of the panel (this shortens the panel width) and with the other hand on the "front" edge of the panel push backwards "after the the edge is released from the a groove in the frame", and out it pops out backwards. (in other words it uses the panels expanded curve to locate in a grove of the frame) Like this ham fisted guy does it putting it in and then pulling it out https://youtu.be/rD-QJ4FoFTE?t=38 This is where the groove will be https://ibb.co/3hWRVTQ This is the Theos ****But you have to disconnect the 3 wire push on Molex connector at the bottom before doing this.**** Cheers George |