2. analog
  3. 124372-9953

Low volume on turntable??

Hi everyone, so I’m new to vinyl and have a lot to learn but I just hooked up a my first turn table, and with my preamp at maximum volume, and amp at full gain, it was still veryy quiet and had no depth/bass. The turntable is an old Denon DP-31L that I just installed a new cartridge in (AT-95E) --->Cary Audio AES SE-3 preamp---->McIntosh MC2125--->Klipsch RP-5’s. The system sounds magnificent running .wav vinyl rips with a Monarchy DIP upsampler--> Emotiva XDA-1 DAC in between my comp and the preamp, so there must be something wrong with either the unit, or how i hooked it up (basic built in RCA to preamp, with the integrated ground wire running to the Mcintosh chassis). On the plus side the ultra-quiet music has no hums, or background distortion whatsoever, even at full volume.

Any advice or thoughts would be much appreciated! Cheers
hockey4496

Showing 2 responses by lewm

lewm
12,456 posts
 
Hockey et al, What surprises me the most is that you perceived apparently decent sound in the first place, with no RIAA corrector in the circuit.  Did you notice a bizarre frequency imbalance?
lewm
12,456 posts
 
Good points, Al and mofi.
There were a slew of products marketed in the 90s, receivers and integrated amplifiers mostly, that had input jacks labeled "phono" and yet contained no phono stage.  The label was to indicate a pair of high level inputs to receive the output of one's outboard phono stage, but its presence caused many to believe they could run the output of a cartridge directly in to those jacks.  I'm not sure if that is what caused confusion for the OP.

More to discover