long i/c run...looking for high end cable


I have a 40ft i/c run from my h/t processor to my monoblocks which are in the front of the room. I've heard that Synergistic Research is one of the best high end i/c for very long runs? Any thoughts or other suggestions? I will be auditioning a pair next week as well as a pair of Vahallas.

thanks,

Jon
jon_p

Showing 4 responses by tbg

And I thought my 4 m. run was long! I have been using the Stealth PGS-3D from Interlink. It is gold litz and excellent. I would prefer Siltech G5 Compass Lake were I Bill Gates. I have tried Pure Note, Jena Labs, and several lesser cables in my 4 m. run, but have found nothing close to the Stealth.
The Vahallas weren't bad?? One thing is for certain, they were expensive.

I would think that half the length would greatly affect the impedance and capacitance. I made the decision sometime ago that my speakers would sound more open were there not all my electronics between them. Putting the equipment racks on the side wall, however, meant long interconnects from the preamp to the amps and crossover. Even my 4 m. length means hanging these ics over the left speaker rather than going behind it. Certainly this does not look as good, but my room is out of sight for visitors.

I wish you good luck. That is about all that I can say as I have yet to find an extraordinary ic in this length that I can afford. The Stealth is the best I have found. I have neither a balanced amp or balanced out preamp, and I do not really understand why that would be much of an advantage. There is also the issue of whether the balancing is just a transformer or is really two circuits.
Sorry to be so long in responding; I am out-of-town. I think there must be several considerations. RFI with unshielded ics might recommend steel conduit that is grounded, but I really worry about such proximity of steel. I do not like to have anything other than ceramics (Suspenders) in contact with even my insulated cables. I would most avoid big power transformers.