2. amps-preamps
  3. 128799-28876

Impedance matching device

I did some searching. There is no shortage of threads on impedance but I don’t find the answer to the following question.

Assuming you have an impedance mismatch between your pre and power amp is there a device which will correct or compensate for this? Can someone supply a link if this beast exists and doesn’t degrade the signal?

I just tried a new used amp (Sumo Andromida II) in my system and I immediately noticed how much more effective the volume control on my VTL 2.5 pre is than it was with my currently out for repair Aragon 8008ST. By the specs the VTL/Aragon should work but it is on the outer limit of what most consider acceptable impedance matching. VTL output impedance is 200 ohms. Aragon input impedance is about 23 K ohms.

It does work and I’ve lived with it for years but now that I’ve tried something else I am wondering if perhaps the performance of the Aragon was being affected by the borderline mismatch. I’m suspicious because I found the Sumo to sound as good if not better than the Aragon in my system.  I expected the opposite. I do realize there are many factors involved but this is a starting point.


energeezer

Showing 2 responses by energeezer

energeezer OP
26 posts
 
Thank you for the responses. It could very well be sensitivity related. Im really not sure.
Hi there, you don't have a borderline mismatch or anything like that.  The VTL should drive an amp with 23 Kohm input impedance just fine.  Why do you think this is a problem?  What do you mean by much more effective volume control?  Perhaps it has something to do with the sensitivity of both the amps.
When used with the Aragon amp the VTL preamp volume control is too sensitive. A tiny movement of the dial makes a huge difference.  It is usable and controllable but just barely.

If you have not sensed any deep bass rolloff with the Aragon/VTL combo, other than what might be expected to result from the speakers, I suspect that improving the impedance match in some manner is unlikely to be worthwhile. Despite the fact that the Aragon’s input impedance is much lower than 45K. 
The bass seems fine. In comparison to the Sumo the treble seems a bit rolled off and mids are dark.  From research I believe that could be a normal sonic characteristic of the Aragon.
There may be nothing wrong. I was just surprised to find the Aragon did not blow the Sumo away and was looking for reasons.
Much has been said of system synergy so when I noticed the volume control issue I figured I'd investigate. 
energeezer OP
26 posts
 
phttp://schiit.com/products/freya

George
That does look nice but I am really happy with my VTL. Something to think about.
More to discover