Ground Hum with Rega RP6, Exact and TT PSU.


Greetings.

Just purchased a Rega RP6, Exact, TTPSU and I am getting a HELL of a hum. I am using an Aragon 47K Phone pre amp. I unplugged the wall wart and the cable which goes from the table and it is still there. I seems to get worse when I turn it on and the tonearm gets close to the center of the arm spindle and it picks up a lot of motor noise. Just sold a 28 year old Linn Axis with a Signet Cartridge and never had this issue with just the normal hiss associated as you turn up the volume. It's not noticeable a lower volumes but it is there during quiet passages and it is extremely annoying. The table sounds way better but the noise is very intrusive and honestly I am disappointed after dropping almost $2000. Thanks in advance
pivetta

Showing 1 response by williewonka

Some carts are known for their  hum problem as they get closer to the motor as the album plays on Rega TT's

Grado is one cart I had to return for this very reason.

Brands of Cart's I've had that do not have a problem on the Rega...
Denon (my current pick)
Nagoka
Rega (of course - but not very good)
Goldring

You may get some reduction in hum if you place a grounded aluminum foil sheet/plate over the cavity that houses the motor - or better still place the foil tape used on HVAC duct work - inside the motor cavity and ground it.

It really is a shortcoming of the Rega TT's

I took the easy way out and replaced the cartridge

Regards - Steve