Thomas, is there a preferred operating point for the Elrog 300b tubes? For example an operating point of 350v across the plate @ 60mA would be considered a traditional operating point for the 300b. Some amps run the 300b at a much higher point for example 400v or even 450v across the plate @80 or 90mA. Thank you.
Elrog 300b's for sale. Your thoughts?
I noticed this morning an add for the new Elrogs. I and many others on the forum ran the experiment when the Elrogs were initially launched. We found the tubes to be superb sonically, but woefully unreliable. In fact, the early failure rate on those tubes was apparently 100%. I and others received replacements that were hand selected for suitability in our particular amps. In fact one individual had 3 pairs fail. In my case, I went so far as to purchase a PS audio power plant, having been assured that limiting incoming voltage to 115V would ensure reasonable lifetime for the Elrogs. Two days ago, one of my replacements failed, after having been nursed along carefully. Honestly, I doubt the tubes had 600 hours on them. So the Psvane T1s went back in and I began the period of mourning for my deceased Elrogs. This morning I awake to the siren song of an ad from a reputable dealer who is announcing availability of the new improved Elrogs with a 1 year warranty. My initial reaction was, "I don't think so. Someone else can run the $1200 experiment. Burned once and lesson learned." But here is the problem. If all of Elrogs former customers take that approach, the new Elrog will also fail even if the tubes are good for 10000 hours, simply because no one will buy them. The tubes are so good that it would be a tragedy if that happened. So the question to all of you who have already been down this road is this? What would it take for you to give these tubes a try again?