2. speakers
  3. 1178500799

Correct imaging

I would like to upgrade the factory spikes on my Helicon�s. I was considering 1.5� spikes, front and rear, from Brass & Granite Audio. However, when I was surfing their website I saw a spike tip which recommended 1.5� spikes on the rear and 2.15� to the front of the speaker to obtain the correct tilt for correct imaging. It is true for all types of speakers or is it design specific? Also is the tilt a function of a distance? Any preferable angle? Thanks for the response!
zurek
4 responses Add your response
nsgarch's avatar
nsgarch
2,524 posts
 
You need three identical spikes/speaker, unless the speaker manufacturer suggests otherwise.
.
hens
173 posts
 
Most quality speakers (and the Helicon's are certainly that) have the issue of time alignment of drivers incorporated into their design, either by using a sloped baffle or having the tweeter slightly recessed relative to mid/bass divers. In this case, using different length spikes causing a back tilt may do more harm than good. Check the literature on the Dali's to see if the drivers are time aligned - I'd be surprised if not.
Ag insider logo xs@2x
jgiacalo
446 posts
 
Check out the Dayton spikes from Parts Express.
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=240-717

I found them a Significant improvement over my stock VonSchweikert spikes. And, only $20.00 for four solid brass spikes.
zurek OP
1 posts
 
Thanks for the responses. I checked the manual and found out that the sound distribution and correct timing were taken into consideration during speaker design, so no need for the tilt is necessary. In this case I will stick with the same spike heights. As far as Dayton spikes are considered do you know what is the tread size (I need M10x1.5)? I would like to keep original mounting holes.
Thanks,
Log in to respond
More to discover
80x80
Acoustic Energy AE-120
80x80
ATC SCM50PT
80x80
Wilson Benesch Eminence