Cartridge loading question

You can get pretty close by ear, but to do it you need a stereo potentiometer, wired as a stereo rheostat, loading the cartridge. I usually use a 100K device.

Turn down the control until the highs seem to go away and then back off. There should be no change in volume, just the highs, which should sound normal and extended but not bright.

You will be compensating for other factors in your system but without instrumentation this means works pretty good.

High output moving iron: The lower the load resistance, the more it will roll off. There is a particular resistance value such that the cartridge will neither ring (overshoot) or be rolled off, this value is known as the 'critical damping' value.

If at critical damping, the cartridge will not have reduced output in any way.

Please note that when insufficiently loaded (load value too high) the cartridge will 'ring' (distort). The distortion will interact with the human ear/ brain system in such a way as to suggest that it is more dynamic. Don't be fooled by this physiological phenomena.

None of this applies to low output moving coil cartridges- that is a different discussion entirely.

If you reread my last post, you will see that you have to obtain the control- a stereo potentiometer and then wire it as a stereo rheostat.

Radio Shack used to sell just the thing for about $5.00; this one should do nicely:
 http://www.ebay.com/itm/2x-ALPHA-C100K-100K-ohm-Dual-Stereo-Potentiometer-Log-Taper-pots-20mm-shaft-...

You have to find some way to get it across the cartridge terminals.

Our preamps have a load strip on the back so its rather easy. Other preamps may only have settings available from the front panel. If that is the case, you'll have to get some connectors too so that the connection can be made prior to the input of the preamp.

The middle pin and one of the outside leads of the potentiometer are wired together, the same in both channels.  The resulting connections are somehow made to connect one to the + output of the cartridge and the other to the - output such that the pot (now wired as a rheostat) is in parallel with the cartridge.

If any of this seems tricky to you, you're going to need some assistance when you set this up.

^^ That does seem like a low value for a moving magnet- I would have expected it to be 10 to 100 times higher!