BIWIRE TERMINALS


when using biwire terminals with single wire speaker cables do you connect your singles to the upper or lower set of terminals and why?
thanks
128x128mboldda1
I recently purchased some JPS Lab speaker cables (single wire). I was shocked at the difference better cables made over the ANCIENT Monster cable I had been using. Now I've upgaded speakers (sort of fell into something and did it) and they can support bi-wiring. It sounds like bi-wiring is the preferred way to go. BUT can someone tell me if anyone manufactures an adaptor that would allow my single-wire positive and negative leads (spade terminations) to be converted to a "bi-wire" termination. I can imagine how to do it crudely with a visit to the hardware store but wonder if there's a product designed for this purpose. Thanks in advance.
I have seen first hand what happens when those just starting to get into hi-fi (as it sounds the initial poster is) are led into uber-geek tweeks by other audiophiles. Last year I had a custiomer bring in a crossover with the speaker cable firmly soldered to it. He said that his receiver had blown up after he did this and he thought it may have had something to do with this GREAT IDEA he had read on the internet. $850 later he had a functional stereo and two crossover sized paper weights with 8ft tethers.

Some tweeks are fine for those who want to get the Nth degree of detail out of their stereo. It is obvious that this fellow has not yet reached the pittiful state of audiophilia that some have. Crawl, then walk, then run, and maybe race the Kenyans one day.
Hey Bignerd, why the attitude? Unsoldering one set of +/- wires from one terminal pair and soldering them to the other terminal pair, is hardly rocket science. It is not a "tweek of the week" but rather a long-term solution for those who believe using a higher quality single wire cable sounds better than bi-wiring. Otherwise, simply use short good quality jumpers or wire, and run the speaker wire to the terminal that sounds best. Some even recommend cross connecting the speaker wire with + on the HF pos terminal and - on the LF neg terminal, then jumping to connect the two neg terminals to each other and the two positive terminals to each other. Here is a link you might find interesting;
http://www.audioasylum.com/audio/cables/messages/126538.html
Yes, get into the speaker and solder the wire directly to the crossover. Every audiophile knows this is the only way to get REALLY good sound.

Or, you could just match + to + and - to - on top or bottom (or even one each if you want) and listen happily. If you are missing the jumpers that connect top to bottom you can make a new set with some extra wire. Just make sure that jumpers only go from like polarities or you may cause a short.

Next week, after you have tried it the normal way, you can email Mitch2 to get the details of how to hardwire your CD player directly to the tempanic membrane of your inner ear.

Good luck!
If you have biwire terminals with no jumpers you SHOUD connect BOTH terminals to a single wire(vertically) otherwise you will only hear freequencies cut-off by crossover and filter.

If you have jumper than it doesn't matter.
Try it both ways and pick what sounds better to you, every speaker is different. If you really want the best sound for this situation, get behind the binding posts and wire the speakers internally to a single post set.