I have this Table, And It would do a world of good if you had a rack with a shelf on points, then make sure your table is LEVEL check this by putting a horizontal level on the plinth then on the platter too. SO,the iso feet you choose should be all the same exact height and not to soft.Some small pucks or disks.look for something like that. And I cant stress enough to have the table on a rack with points on the floor and a shelf with points also. Heck with my rack and shelf I don't even use iso under the table.But if I did ,I would use something like i described.
Best T/T Pods/ wood blocks to eliminate vibrations
My table is 3 feet from the right speaker. When the tonearm is in play, knocking on the table plinth or dust cover creates an amplified thumping sound. The table is a Rega P3-24 and has THREE rubber cone feet that are not removable (There are two in the front and one support in the middle at the back of the T/T. The table sounds good, but I know that feedback is degrading the sound. Need recommendations for either footers, pods, points, or blocks to eliminate that thumping sound. BTW, I can not use a wall shelf because the walls are concrete, and also cannot be drilled