2. cables
  3. 1346360033

Bal. Cables for Wadia S7i CD player?

I'm in the process of purchasing a Wadia S7i CDP. I need to run 2 meters to my Bryston 7Bst's (I'm running direct). Looking for suggestions for Interconnects that work well. (Don't want to have to sell the house to get good cables)
Also has anyone compared unbalanced to balance since I already have good unbalanced.
Thanks for your input!!
2bz

Showing 3 responses by 2bz

2bz OP
38 posts
 
Any experience out there with XLO Sig 3 or Unlimited? The little I read, I keep hearing about neutrality "Sounds like nothing at all" Can't find too much on these but was hoping fellow Audiogoners had some input.
tnx!!
2bz OP
38 posts
 
Lloydlee:
I was looking into Transparent Super and Ultra. My only hesitation came when I read that the "Network" used does wonders for the low frequencies at a cost to the highs. My highs (hearing) are rolling off as I get older. Whats your opinion the Transparent's effect on the high freq's. I tend to like detail over warmth.
tnx...2bz.
2bz OP
38 posts
 
Hi Jafant,

I run my Wadia both Bal. and Unbal.

Bal.: XLO sig 3 into Bryston BP26 pre-amp then the Bryston Van Damme Tour Grade Classic XKE mic. cable(stock code# 268-020-000) from the pre-amp to my new Bryston 7B3 monoblocs.

Unbal: Silver Audio Silver Bullets #6 From the Wadia direct into the Bryston amp. This has been a nice option with my old 7bst amps but haven't tried them with the new 7B3's (just connected those yesterday and haven't played around much yet.

Most of my listening is via Bal.
More to discover