2. amps-preamps
  3. 1075159284

Audiolab 8000A and 8000S

I currently own an Audiolab 8000S used as an integrated amp. I have just acquired a secondhand Audiolab 8000A . I would like to set these up in a pre/power configuration , but not sure which amp to use for which purpose. Can the 8000A be set up as a power amp?
The 8000S has a number of modes but Im not sure if any make it usable as a power amp .
I am a little out of my depth here so any assistance would be much appreciated.
paulfoly3c96

Showing 2 responses by nutella

nutella
223 posts
 
The 8000A has pre out and power in jacks and can be used as a pre or a power amp. To be used as a preamp, simply connect to a power amp. The pre and power sections are connected internally. To be used as a power amp, this connection needs to be removed. With this done, the pre and power sections can operate independantly.
nutella
223 posts
 
I was paraphrasing the audiolab owner's manual. I have not performed the mod on my old unit. The manual does use the words "simple modification". If you feel confident in looking inside, you may be able to see for yourself if you can do it yourself. Otherwies, take it to an electronics repair shop and tell them what you need done. It should only cost their minimum charge. If you do choose to look inside yourself, remember that even if the unit is unplugged, there may still be enough voltage in the circuits to cause injury. Leave it unplugged for a while before you do anything.
More to discover