Agree with Al 100%. As long as you can get it to play as loud as you want without excessive noise you are fine. It doesn't really matter where the volume control is. 2/3 of max is fine. You are not going to hurt anything. Generally speaking the more wide open the volume control the better it will sound' There is no need to be paranoid about the volume control. Lose the SUT.
Audio Research PH5 Phono Preamplifier Input Clipping Problem
I have an ARC PH5 phono preamplifier and most of the time it sounds fine. But on a few of my favorite LP's with wide dynamic range, it will clip and distort on loud sections, especially those with lots of bass content. This only happens with use of a step-up transformer, without the SUT in line, there is no clipping. I do prefer to use the SUT, as without it I have to turn the volume setting on my ARC REF 3 preamp to a very high level. I have to conclude that the PH5 is distorting because of high input signal levels, due to the gain of the SUT. I have tried two SUT's, one with 13:1 and the other at 7:1, both exhibit the same problem (although the lower gain SUT is much better). The cartridge is Ortofon A90 with .27 mv output. Given this, would you expect clipping or do you think there is something wrong with the PH5? I have talked to ARC about this issue, and they seem to think that there is a chance the PH5's maximum input of 70 mv is being reached on these loud sections. Would appreciate opinions from those that have experience with a similar setup. Thanks.