Whatever you need can be found here:(http://www.percyaudio.com/Catalog.pdf) And Michael will also match whatever you order within 1% tolerance. I've dealt with him for years and have yet to be disappointed. Normally I use Vishay Bulk Foil resistors in projects, but actually wire-wounds are known to be quietest. Alpha Cores are the best inductors around, but(as mentioned)a resistance mismatch can cause a shift in your roll off points. The Percy catalog will give you a lot of other ideas also(cabinet damping, binding posts, internal wiring, etc.). Have fun!!
Attn: Speaker DIY expert
I want to upgrade the crossover on my DIY monitor. It's a Jim Griffin design with Jordan JX92s and Aurum Cantus drivers. I put some no name brand crossover parts from Radioshack on it . Can somebody tell me what is the best capacitor, resistor and coil to buy. Please include the type and brand and the store where I can buy them.
Here is the list of parts that I need:
L1 = 1.5 mH 16 awg.
L2 = 0.3 mH 20 awg.
C1 = 6.8 uf
C2 = 5.1 uf
C3 = 15 uf
R1 = 8 ohms 10W
R2 = 3 ohms 10W
R3 = 1 ohm 10W
PCB board.
Thanks everyone, I appreciate taking your time.
Here is the list of parts that I need:
L1 = 1.5 mH 16 awg.
L2 = 0.3 mH 20 awg.
C1 = 6.8 uf
C2 = 5.1 uf
C3 = 15 uf
R1 = 8 ohms 10W
R2 = 3 ohms 10W
R3 = 1 ohm 10W
PCB board.
Thanks everyone, I appreciate taking your time.