As An Experiment I Stuck A Few Things Under My Pre-Amp And Am Now On A Quest


My system is built out, got the pieces I want in place, and struggled a bit with how it sounds. With certain recordings it was sublime and with others it could be a bit sterile or mechanical sounding. These are all solid state components in a Salamander cabinet, and up to this point I have never been a fan of isolation devices with SS gear. Now with tube components I did use spike type devices under amps and preamps, so I have had a bit of experience.

Last night I rounded up a few wayward isolation devices I had from previous systems and thought I would experiment a bit. The pre-amp contains the DAC also, so I thought I would start here. Put in some Wagner type pads, and got a different sound with some improved focus but the bass was lean and a bit odd. But things changed. I tried some magnetic pods I had, no change with them.

Then as a whim I cut two sections of foam pool noodle I had laying around and put it under the front and back of the preamp. I oriented them lengthwise. Something fantastic happened here! I got spooky precise focus to instruments, the bass response became impactful, the sound is more relaxed...perhaps a bit too smooth but I will take this over that mechanical presentation any day. This is sounding very nice.

So, after dinner I decide to cut a third one and perhaps the bass gets better. I put it in and all the gains are gone, it sounds worse than the first set of Wagner pads I put in. The bass literally vanishes and the soundstage collapses. Pull it out and things are good again. I listen to disc after disc last night and am pleased with the sound. I am spinning vinyl this morning and still feel the same way.

So now I have a plan of action. On one hand I am content to leave the noodles in place and roll with that for awhile. It would be nice to have a permanent solution though. It seems like I am looking for a compliant solution. I remember Brightstar used to build a little shelf that housed a bike inner tube in it, and I think Townshend Audio also had a bladder type platform.

It would be interesting to know what products folks have used that functioned in a similar manner.

Thanks for sharing any thoughts or experiences.

neonknight

Showing 1 response by gregm

Hi, I have dabbled in all sorts of isolation, coupling and decoupling devices. Ultimately I find the best sound (clarity, extended FR esp bass) are ball-bearing / maglev devices.

Bladders / inner tyre tubes give muddy bass (i.e louder but bloated) and slower perceived sound.

I like fast transients, overall speed, and dynamics. I use these (the "Lyd") which are expensive, but there are others (stillpoints, isoacoustics' Gaia, etc).

I recommend you try a reasonably priced chinese offering like this. If tyou don't like the sound the pucks can always be used elsewhere.