2. analog
  3. 1111626917

Anyone using a Graham 2.2 with the Aries 2?

I have the Aries 2 TT and currently have the JMW 10 arm. I also have the circular 4 layer Graham arm board made for the Aries. I dont see there would be any problem with the Aries2 as its the same mount..however, since the 2's platter/ bearing is about 3/8' higher than the older Aries TNT metal/acrylic..I wonder if all that is required is to raise the arm height to compensate, whiich would be simple enough. Anyone currently using this combo and find it works ok?
Thanks for your comments. Ken
128x128kehut
3 responses Add your response
kehut's avatar
kehut OP
668 posts
 
No one is using a Graham 2.2 on an Aries 2?? Really? Hmmm
divo
60 posts
 
I had to put spacer washers uder the arm board to raise it.
Arm height adjustment range was insufficient.
kehut's avatar
kehut OP
668 posts
 
Hi Divo,

Thanks for your input here. I was afraid that may be the case. The Graham can adjust just so high...but thought it may or may not work as I really wasn't sure with the newer platter height.

Did you upgrade to the 2.2 from the JMW?? and if so, what are your thoughts of the differences sonically?? Thanks, ken
Log in to respond
More to discover
80x80
Kuzma 4 Point 14”
80x80
Lenco Fenrir
80x80
Gold Note Pianosa