Any advantage or dis whn bolting rack to wall?????


Hello all,
I just made my own rack and with my physical and monetary limitations I am very proud of my efforts, it is almost 60 inches in height made from MDF for the shelves with Oak legs, but being above the basement it does rock slightly so I was curious about mounting a bracket to a stud and anchoring it to the back wall, is this a good or bad idea? I do have isolation pucks under most important peices untill I can get more, or I may use Brss Achorns under the remaining componets for a cheap tweak, any ideas? thanks once again everyone.
chadnliz

Showing 1 response by the_chops

When I custom made my own shelfs, I used 16-inch wide slabs of marble with blue/gray viens, These shelfs are (6)feet long. Each marble shelf is,(1)inch thick,& there are five shelfs stacked about 18 inches apart, all the way up the living room wall,on a load bearing wall.

What holds these shelfs in place are, glass-dowel rods (hand-made/ blown),solid crystal glass. Each dowel-rod is two inches round & 18 inches long, & are spotted in equal lengths, across the whole 6-foot distance,on each shelf. Between these glass dowel rods & the Marble, I have rubber,Vibro-Pods on both sides sanwiched in between the rods & the White Marble.

The back-wall has solid oak, 2"X 2" trim pieces that are attached with wood screws to the studs in the wall.This runs the horizontal length of my walls,& holds up the back sides of this marble.

I also have two spot-lights mounted on track lighting, in my ceiling above these shelfs, they have black light bulbs installed. & At night, I turn them on, & Man!!! you should see how it lights up the white marble & shines like a spectrum through those glass dowl rods. Whew~Wee !!!!

Underneath all this marble shefing, is a poured slab of concrete about five inches thick. That way, you can dance, jump up & down & my Oracle Delphi Mark V Turntable, & my Benz Micro Glider cartridge does not even know that I'm in the same room.

How's that for permanent fixings ???

Mike (The_Chops)....