2. amps-preamps
  3. 179211-174339

Amp Internal Wire

Hi Gents, has anyone have any experience with upgrading amp or preamp internal signal wire? Most older equipment seems to have thin maybe sometimes poor internal wiring. In the world of OFC/OCC/Sterling and even more exotic wire available these days, any experiments done using this internally on components swapping out the cheap?

Lots of discussion about doing this with speakers, but never with components I've seen. For instance, I am thinking about replacing copper 'appliance' wire in an old Bryston with 14awg sterling from the board to the speaker binding post board.

 

Any thoughts?

rickysnit

Showing 1 response by sgreg1

sgreg1
612 posts
 

Would it not make more logic to just buy a new amp?

Then if you are going to replace the wire should you not replace all other components and the power supply. What about replace all the connection points.? Again just buy a new amp! Your logic is to replace a perceived weak link and will just make another link the weak link and on and on?

More to discover