raam

Responses from raam

Bananas rule, spades drool. End of discussion.
The absolute best it to hard wire everything, no cable ends or connectors, even wire the speaker lead directly to the speaker wires, just support them really well. Obviously this is not a good option for most and I do not do all of it though I mi... 
Battle of the Open Baffles
Once I build something as a test bed for what I want to achieve, get it working, etc then I do many things like directly wired drivers, quality wire, quality xover parts as needed and work on time alignment. I plan to use high grade materials for ... 
Cable Break In for the Naysayers
My only experience in turning a cable 180 degrees, the only one I have done and it was an error, not an experiment, was using Star Quad DIY cables, of which I always make up and use. I attach the shield at the input end and cut it back and tuck it... 
Cable Break In for the Naysayers
I recently took a look at some rather good threads on that site and found there are those that are far more open minded than I thought would be the case. Of course there are those that are very closed minded as well. I believe all things are possi... 
Battle of the Open Baffles
I have five 6x30 watt AB amps, can be bridged to 4x60 +2x30, etc...so looking at starting out all active until final speaker selection is done. Evenutally I would like to use an SET amp, or at least mids and tweets on the system.  
Battle of the Open Baffles
I am building the XDS and really hope I can get them to work in my very limited place of residence, full time RV. I added 1.5 to the rear length and stiffened it up greatly so I could have enough space behind them or any speaker design I find the ... 
Cable Break In for the Naysayers
Not sure I have written about this here but I have plenty of experience in test gear use as spent 20 years in the US Navy as first a Data Systems Tech then it was merged with Fire Control Tech and re-titled that. The most complex gear I worked on,... 
Cable Break In for the Naysayers
I agree absolutely with getting the room right is far more important than cables can possibly be whether they make a difference or not. As for cables, there are things we just do not know and might not for generations to come, real science is a bu... 
Cable Break In for the Naysayers
I also believe, not know, that once past a certain point, break in, design, cost....the law of diminishing returns hits pretty hard, mostly what we start getting into is differences and those can be quite profound and enable that synergy so often ... 
Cable Break In for the Naysayers
Anyone who thinks if cannot be a possibility if it cannot be measured has a bit of a head in the sand(or a darker place)issue as we have barely begun to even design test gear capable of such measurements, let alone fully understand some of the mos... 
Cable Break In for the Naysayers
Those who claim absolutes seem rather narrow minded and ignore real science as it actually has shown us many things and will continue to do so. As as touched upon by another poster all there is is a lot of energy and maybe just a tiny bit of mass ... 
Sub $1000 DAC with AKM chip
I am a big fan of AKM and R2R DACs, my current DAC is the Topping E70 Velvet which uses two of the top line AKM chips and is a bit between the higher end ESS and most other in AKM DACs in a bit more I guess I could say lively sounding. I like horn... 
Speaker Cables : Moderate priced
Life long DIYer, been running nothing but Canare interconnects for around 25 years and never bother with anything else, cheap to build, sound superb in mobile and home audio, single ended and balanced. I have never tried their speaker cables, just... 
Integrating speakers into contemporary decor - can WAF ever be overcome?
Partners, equal, you have the right to have some great speakers, make that plain and to the point of not in contention. Then offer to let her help you pick them out, emphasis on help. If she refuses to work this out then you are already on a slipp... 
Air conditioning for audiophiles.
Got a bit of a buzz on right now so maybe not posting my best.... This is a great thread, thanks OP, my comments might not pertain to most here but some great posts have been made, good topic:)   Rick