danmar123
Responses from danmar123
Linlai KT88 experience? I’m not surprised on how the Linlai tubes are as good as they are. I’m running the Global E in your personal pre-amp you sold me & like them as much as all my NOS JANs in my stash. I’m curious on how they would stack up against the K&R kt8... | |
Ultrasonic cleaning I pre-wash with Grove Washer G2, then bathe for 10 to 15 min. in my Ultrasonic cleaner using Reverse Osmosis water. A+ | |
Your best ''outstanding'' products in last 5 yrs? EMT 948 & MRB Cartridge. | |
Flat copper speaker cables I have Taralabs, that are solid flat if your interested. | |
Speaker Cable Recommendation @tvrgeek, I use the 12/14&16 gauge for my basement setup, with nice results. My main setup, I use, Furutech OCC wire. FS-36, made a significant improvement over the Monoprice 4/12 I was using before. | |
Mains Power Cable DIY Conclusion; The cable made no significant change on my table. Maybe I'll try it out on my amp, which has an Ice Age cable there already. | |
Experience with Modwright products? I have Dan's 9.0 Phone Pre. & I agree with your comment on his personality, but I can't see the cost of the upgrade to his X model, as my system sounds steller to me already. | |
Tweeter protection Thank you Gents. I just went for $500.00 plus for 4 new diaphragms. It must be that when I recalibrate my AVR, it's set to high. | |
Tweeter protection Thanks. Will do. | |
Can you live with your current speaker until you die? Yes, you can see my front end in my system. I'm just curious how the new Tannoy SGM15s would sound? | |
Mains Power Cable DIY Follow up on: I 've been making own my power cables for years now. This morning I purchased; FURUTECH FP-S35TC PC-TripleC new technology & Schuko Furutech FI-E50 FI-50M FI-50 NCF Nano Crystal. I believe in burn in, so I'm going to switch out... | |
New Technics SL-1200GR2 Yes. Also the GAE. | |
New Technics SL-1200GR2 @martinman , Upgrading the PC, RCA’s, tonearm & also feet. All worth the time. | |
New Technics SL-1200GR2 OK, I have an modded 1200mk2 since the early 80s & also have the GAE. I’ve done an arm swap on the GAE with an SME 309 & installed the GAE arm on my 1200, very noticeable difference over the stck arm w/wire upgrade. Now @billstevenson wrot... | |
Mains Power Cable DIY @dalims4 , SSSHHHHHHH 😜 |