bridging integrated amplifier

Thanks for all the input, I'm following Sandstone's advice. My setup is for my home office and I have limited desk space. I run 2 small speakers next to each other, but I have single large bookshelf that can take up the same space and would give me more low end. I was looking to take advantage of the power options from the stereo but rather not risk off wiring.

but I have single large bookshelf that can take up the same space and would give me more low end. I was looking to take advantage of the power options from the stereo but rather not risk off wiring.
Rome2000 (Threads | Answers | This Thread)

Make sure the speaker is rated at 8 ohms for the 8 ohm setting. If it is a 4 ohm speaker, use the 4 ohm setting. Otherwise, the one channel it's running on can overheat and get damaged. Using the mono setting will make sure you hear both left and right channels, through the single speaker.

Rome,
One additional thought - if your single speaker is able to be biwired - that is, has separate sets of connectors for low-frequency and high-frequency ranges, you should actually be able to connect both "channels" of your receiver while in mono mode. Remove the speaker's jumpers and then conventionally connect "left channel" outputs to one set of terminals and then "right channel" outputs to the other. Both channels would actually be outputting in mono mode. Not sure whether this will actually deliver more power or better dynamics but it may be worth a try.
Best,