Difference between SET and push-pull using 300B

Properly designed push-pull can be as good as SET amp. 100.000$ Kondo Gaku-OH is a push-pull.

I think that it would greatly depend on the music that you listen to. The SET has the most AIRY HIGHS and the BEST MID. The PUSH PULL configuration will have more watts and will have better control of the Bass perhaps sound somewhat puncher, but I think that the mid and the highs suffer somewhat.

In case of Zanden 9000 dont forget that this not just a push pull design but like kondos gakuh-on a very special superior design to most others.

Basicaly, in a SE configuration you have one output device (tube, MOSFET, transistor, ...) which is usually working in A-class. That means that it is always open and transmits the whole "sinusoide" - actually the whole signal. It usually get very hot, and the losses to the heat are considerable. This design is probably the oldest one (with WE 300B).

Push-Pull design has two output devices at the output. Each device transmitts the half of the sinusoide. PP devices can work though in different classes. They are usually more efficient and provide more power at the output than SE. That is why they are preffered solution with more critical loudspeakers.

Typically SE is considered as superior design in respect of sound reproduction. It has though some limitations - the most important one is the power that it can provide and accordingly, the matching with appropriate speakers. PP can be also extremly successful in sound reproduction. It depends actually on implementation; output devices that are used; quality of transformers; etc. So there are seriously sounding PP designs as well as poor sounding SEs ...

I wouldn't worry though to much about all this. Listen to this amp (if possible with your speakers) and see whether you are happy with the sound. If yes ... then ... no problem which internal design has been implemented.

The primary issue between SE and PP is the output transformer, although PP often has some additional circuit complexity. But its the transformer that makes the difference.

When running PP, the signal has to go from positive to negative and then the other way. Magnetics being what they are, they resist the change in polarity. This is called hysteresis loss. In a SE amp, all that is happening is that the current through the transformer is changing intensity, but never polarity: there is no hysteresis loss.

Due to hysteresis loss, a little bit of extra energy is required to change the polarity. This energy comes from the low level signal, essentially trading distortion for signal. That is why SETs have such great low level detail. Of course, PP has bandwidth that SETs cannot match.

Take away the output transformer and you take with it the issues of hysteresis loss- and any argument for SET. Then you can have the low level detail and the bandwidth at the same time. To my knowledge though, there was only one 300b true OTL ever built, and it was a prototype. OTLs need different tubes that are lower impedance, and they have their own requirements for speakers, although they can usually drive anything an SET or other low-powered PP amp can.