Will this set up work? biamping with different amps and subs

Paul,

According to the Audio's 42nd Annual Equipment Directory, the Gershman SW-1s have a sensitivity rating of 87 dB/watt, and I didn't see any specs on the crossover, although judging from the low frequency range of the intended Gershman satellites (to 40 Hz) the crossover may be set low enough for you to use as-is and let your main speakers roll off naturally. I would contact Gershman for information on the crossover point. The difference in sensitivity, however, may force you to use the EVS attenuators to turn down the main speakers (which appear to be more efficient), rather than the subs -- so you may in effect be adding a passive preamp in line with your main speakers, to make this mating work. Also, depending on the crossover point of the sub's internal crossover (if any) you may need to remove the crossover (if it's set too low) and get an adjustable external crossover to obtain optimum results. It sounds like you might be in for a little experimenting. Good luck.

Paul--

I forgot to mention that the difference in the input sensitivities of the two respective amplifiers will also factor into the relative volume levels of the satellites versus the mains. Who knows, if the difference works in your favor, you might not need the attenuators at all -- however, the odds of that occurring would be akin to hitting the lottery.

I would say try it and see. Going by what you have stated and Plato was kind enough to add in terms of technical data, it sounds like the subs would always be trying to play "catch up". As such, they might offer low bass reinforcement at a much lower output level but not enough to be level matched to the mains.

Running the subs in this manner will add to the sense of low bass while not making it stick out like a sore thumb or being very noticeable. This should work out okay as it would only be giving you more of what was already there with the mains. If you were to attenuate the mains down to a similar level that the subs generated, you would probably need a bigger amp than what your SET stuff was capable of.

So, if you've already got the stuff, it will cost nothing to find out...... Sean
>

I would use the POWER 2, because I own them. In fact, I could even try to connect a pair of BC-2 Monoblocks to drive the sub, but I doubt it will have enough juice to run them loud enough.