Rega RP3 or Pro-ject Expression III?

Go Rega... I know I'll take heat, but Projects do not play the music. Period.
Compare, and write back...

I own a 1Xpression. Would have bought a Rega P3 if I had a local dealer at the time, to be honest. The P3-24 was even better than the P3.

Haven't heard nor seen the RP3, so I can't say for certain about that one.

The Xpressions are very well made and reliable IMO. Not a single problem with mine in about 7 years. Rega's decks have also been pretty solid.

If you buy the Xpression, replace the stock Oyster cart as soon as possible. It's absolute crap. I have a Dynavector 10x5 on mine, which is the upper limit of carts on it IMO. The Xpression's strong point is the tonearm.

I'm not a fan of Rega's carts at all. A lot of people like them though.

I'm not trying to get you to spend more money before you buy, but you should take a serious look at either Pro-Ject's Speed Box or Rega's TTPSU once you get up and running for a bit. Both a a very good upgrade to their respective deck. They'll easily take it up to the next level (again, haven't heard the RP3; basing this on all previous P3s).

Looking at only those two tables, I'd say go for the RP3.

If it were me, I'd look for a used P3-24 with the TTPSU. As Kbarkamian said, it's a great upgrade and I have no doubt you could get a mint used P3-24/TTPSU combo for the same money as either the RP3 or Expression III new.

If it was me, I would go Rega, it probably offers more paths to upgrade in the future (ie: plater, arm, motor).

Thanks for your thoughts, everyone. I went ahead and ordered an RP3 from my local dealer tonight. His demo model sounded sweet through a pair of B&W 802D's--hopefully it sounds good through my Lores, too.

I a/b'd it against an RP1 while I was there, and, as one would hope, the RP3 sounded significantly better. Not sure how much of hat had to do with the cartridge, though.

--Alex