Can you run the HANA SL MC at 100 ohms?

Reviving this again...

I was thinking of revisiting the other resistance settings again (Moon 310LP), so I opened the OM and I noticed this:

"Finally, it is strongly recommended that you never use the 47kΩ resistive load setting for moving coil cartridges."

Hope I didn’t hurt anything...

Should I stop using 47K with my MC Hana?

EDIT: I started with 100 and it sounds so good, more organic and natural. Not sure what I saw in 47k before, but this sounds incredible. I don't think I will be using 47k again, hopefully no lasting damage. 

No you cannot hurt anything with the “wrong” phono load resistance, and whoever wrote that bit of advice about never using 47K to load an MC cartridge is full of crap. It has been mentioned before on this thread, but in case you hadn’t read it, you can make a stronger case that 100 ohms is the wrong load for a Hana cartridge with an internal resistance of 40 ohms. The rule of thumb says you should load that cartridge with 400 ohms or higher resistance. But it still isn’t wrong to try 100 ohms. If you like it just recognize that by loading that cartridge with 100 ohms, you are likely to be rolling off the high frequencies, possibly within the audible range. Plus, you are losing some of the gain of the cartridge.

Good, thanks. I can't hear above about 10-14KHz anyway... I'll try 470 again also, but 100 is sounding great. I also listen at ~60-70 dB with 95 dB efficient spks, so gain is not an issue.