Which Preamp Tube is most consequential: Input or Gain


I've just gotten a pair of 1950s Tung-Sols for my Schiit Freya to replace two of the stock Russian NOS 6SN7. I will try them in both positions, but is there a typical position of more impact in terms of rolling preamp tubes in the input vs. gain positions? Thanks for any experience you'd like to share.
peterf6
Thanks @rickytickytwo . @ghasley The impact of the Tung-Sols on the right was much richer bass, on the left the bass seemed good but more in balance and everything else got nice and airy with good soundstage. So while rolling better tubes might not shift things much, stepping up from the stock 6Sn8s did. I guess I'll eventually pick up another pair and replace the remaining 2 stock tubes.Thanks for the vendor recommendations!

Place your best tubes on the right hand side forward and rear

Why would you install the new tubes in the right channel gain and cathode follower?
The new tubes go in L and R channel, either front or back.
Front would be the gain stage, unless Freya has an odd design.



Thanks, @lowrider57 , the Freya has two tubes per channel. Forward and rear are L/R channels; while the two left tubes are Input and two rights are Cathode follower. So I've been changing the two inputs or the two outputs to keep the channels the same.
@peterf6 , ok thanks for your comments. That’s a different layout than preamps I’ve owned. Typically, tube circuit is L R in front. 
And of course, Ralph (atmasphere) is correct.