I have added an IEC receptacle to several of my older components with great success! It is fairly easy, and the vast array of powercord tech is then at your dispense. As a matter of fact most of the gear was mid fi and it responded very well. Just order a couple of receptacles, get a dremel tool with some cutoff disc. Make a pattern for the opening , mark tht rear panel and take your time. It usually takes me about 1.5 hours, then used canned air to clean out debris and connect. This process has now been made easier with the new IEC receptacles which have screw connections. Give it a try it is WELL WORTH the time and the older powercords are very inexpensive here on Audiogon.
A better lamp cord for my stereo equipment?
A lot of space goes to the 14, 12, 10 gauge, monster-sized, plug in, power cables. Rightfully so. I have my favorite power cables in place on my amps and also on some of my source equipment. But, some of us have older pieces in our systems and many of these older pieces do not have the plug in, switchable cords. I have a few pieces that were built with the old, permanent, lamp cords.
I've alwys wondered about those cords, but I never see any posts about them. Service people don't like the idea of drilling out the cord opening in older equipment to allow for thicker gauge wires, so we seem to be stuck with similar sized cords.
Have any of you ever upgraded/replaced your cords on older equipment? Do you know of a better grade of lamp cord out there? Would just replacing the plug help?
I've alwys wondered about those cords, but I never see any posts about them. Service people don't like the idea of drilling out the cord opening in older equipment to allow for thicker gauge wires, so we seem to be stuck with similar sized cords.
Have any of you ever upgraded/replaced your cords on older equipment? Do you know of a better grade of lamp cord out there? Would just replacing the plug help?
- ...
- 23 posts total
- 23 posts total