do i need some attenuator because signal ouput from Cd player is higher than the tape inputs No. The "tape in" and "AUX" inputs are line level inputs. Just don’t try to use the phono preamp input. Is there a reason you can not use the AUX input for the CDP? https://s-media-cache-ak0.pinimg.com/originals/3c/41/56/3c4156464ee08bcd344360aca955ee86.jpg |
thanks but i tried both Aux and monitor tape 1 or 2 i dont understand why the monitor tapes inputs sounds better to me and the aux sounds louder but too much mids a highs a little bit exagerated i read many people prefer the monitor over the aux . People said output of cdp are 2V and input line are 150mv and so . Claim that for aux is 13X times more and for monitor inputs are only 6X times and these can damage the receiver Thanks |
i tried both Aux and monitor tape 1 or 2 i dont understand why the monitor tapes inputs sounds better to me and the aux sounds louder but too much mids a highs a little bit exagerated i read many people prefer the monitor over the aux .Make sure the "Loudness Switch" is in the off position. People said output of cdp are 2V and input line are 150mv and so .I believe the "tape in" inputs and "AUX" inputs are 2v I could not find an owners manual for the SX-880. Here is the service manual for the SX-880. Note the #3 Block Diagram. http://akdatabase.org/AKview/albums/userpics/10004/Pioneer%20SX880%20Service.pdf |
Loudness is off i ve already had the same services file from that data base well what i m trying to do now is adjust dc power offset to hjave the same level in each channel because now right channel is louder but the diagram is uncomplete picture and instructios refering some pointed numbers not showed at photo ????? Thanks |
