Tube Preamp and SS Amps - How?

You will find this out. Using a tube preamp and solid state amp will give you very good transparancy but lowend and dynamics will suffer somewhat but still be good. if you listen at lower levels tube preamp great. Ive used Audio research LS1. LS 2bII balanced. Audible illusionsM3A. I now have a krell KBL Balanced that just blows the other 3 away in dynamics but isnt quite as airy or transparnt. A good trade off on my side. Thru a krell ksa250 amp. (Killer). Ihave used enough giant amps fill this page and always end up with the ksa250. My 3rd one. good luck!!

Here's the missing bit of info:
if the ratio of the pre's output impedance vs. amp's input impedance is marginal, then keep the interconnects SHORT. 2 meters or less is recommended. If you have to have long interconnects, your chances of success are better with a balanced (XLR/XLR) system. Worst case scenario: preamp w/ 500 ohm output impedance driving 20 ft of RCA/RCA cable into an amp w/ 10k ohm input impedance.
Best of luck,
Joe

Folks it is not only the impedance matching you should take into the consideration.

In general SS amps give out full power with just 1V or bellow at input and tube preamps might have an extraneous gain. Many tube preamps have can be noisy if paired with sencitive SS amps at low volume levels. The good solution is to have a low gain tube preamp with SS power amps.

So wouldn't passive preamps work best?

I'd say that with SS that have >=47K impedance passives will do the best job for the money invested indeed.