Why no Danley fever?

you'd probably want an outboard crossover to integrate their sub with the mains, but the mains themselves do not require outboard crossovers.

Also, please be aware that the synergy horns are highly directional by design- a 50 degree radiation pattern. They do this so you can control where the sound goes - more importantly, where it does not (i.e. avoid washing the walls of a performing arts theater where the reflections might cause smearing and phase/frequency cancellations).

They operate as "point source" speakers because all drivers are loaded into the same horn so they appear pretty focused in that regard. However, I believe the crossovers are not adjusted for phase accuracy (my understanding though I've never really looked into it) or time aligned. So, while they sound like point source, there are likely to be some discontinuities when listened to in a living room. These are immaterial in the settings in which they're normally used - most listeners are probably 50' to 200' away. A living room is practically near field listening.
That said, they'll make a killer system if none of the above are discouraging.

Johny_1 is correct - these are pro-audio speakers. However, as remarkable as they are - and they are very good for the genre and much better than the vast majority of "pro audio" equipment (most of which sounds horrible), they are no match for any decent home equipment. Pro-audio has entirely different requirements:
ability to play at very loud volumes without strain (i.e. fill a performing arts center or a stadium)
high efficiency
reasonable weight so they can be setup and taken down for shows (plywood cabinets that aren't too thick (lots of cabinet vibration)
reasonable cost or no sound contractors will spec them - simple black paint, fly points, very simple crossovers.

Yes - I actually do have plenty of real experience in pro-audio and in home audio. If you want the ability to play 120 db in your home, Danley is a far better choice than most other pro audio gear. If you want to hear resolution, accuracy and balance at something less than saturn rocket levels then most any decent audiophile speaker will handily outperform because the design considerations are completely different.
Peace

Bwaslo: I think you may have misunderstood my response. I think Danley makes some of the best sounding pro audio speakers out there. I spec'd Danley for a new performing arts center and they modeled out great in the analysis. The facility is being built, but I expect it to sound terrific when finished.

However...
I stand by my previous comments that their different design objectives mean certain compromises have been made in important areas such that they won't fully stand against most speakers that people on this forum would consider good.
Physics are at play here. Unless you believe that cabinets, crossovers, etc have no impact on sound,there's only so much that can be done. The design objectives are very different for the two markets.
Again, Danley's are probably the best sounding pro-audio speakers out there - and I've heard very many of them when doing sound. However, to my ears, I'll take well engineered home audio equipment for my home. Of course, my $.02 only.
Peace.