2. amps-preamps
  3. 1216941383

Using a Digital Multimeter for the first time

After 15 years of service I replaced my old voltmeter with a Radio Shack Digital Multimeter.The instructions read that the amps should be turned off when inserting the leads. This would mean that after playing the amp for 2 hours I would have to turn them off insert the leads and then turn the amp back on.I doubt if I could get an accurate reading this way but Radio Shack says I could.So,I ask for your opinions.
Thanks all
oem
w_barton
16 posts
 
they put that blurb in there for safety reasons. It would be more correct if you would measure it like you suggested.
The reason you would want to change the smoked component is that it will have latent failure associated with the smoke and eventually derate its performance. Over a period of time the heat and increased resistance would eventually breake it down until it will no longer function and you would be wondering what happened.
Post removed 
minorl
1,014 posts
 

Voltage on a digital multimeter looks like an open circuit to the circuitry you are trying to measure.  Therefore, it can't hurt the measure while the circuitry is "hot" as long as you are in the correct setting.

If, however, you inserted the leads with the circuitry on, but the multi meter off, you ran the very real risk of a short circuit when turning your meter on.

it looks like the OP made the simple but easy to make mistake of shorting the circuit by having the multimeter on the wrong setting.  Either Ohms, or current, and not voltage. 

I can't think of one Engineer or Technician that I know, including myself that has no fried a circuit by not paying attention to the setting on the multimeter.

I would open the amp (unplug it first) and do a very close inspection of the circuit boards to see if there are burned traces or components.  Look closely.

Something was going bad and fried, or partially fried.

take a look.

enjoy

More to discover