Tonearm relative to Plinth alignment


I have a Linn Basik turntable with a Linn Basik Plus tonearm (bought separately), and when the tonearm is in its arm rest it is not completely parallel with the side of the turntable. It appears to be a few degrees on its way to the platter. There are 3 holes in the table for the screws to the base of the tonearm, and they must be rotated a little bit.

Will this affect the sound of the turntable?

Thanks,
Dusty
128x128heyitsmedusty
The only relevant parameter in locating the tonearm on the plinth, is the distance from spindle-center to tonearm-center. At the correct distance, the tonearm can be located anywhere around spindle. If the tonearm is not parallel with the edge of the plinth when at rest(and this bothers you) then move the tonearm rest so that the arc of the tonearm when it's at rest stops so that the arm is parallel.
I agree with Bdgregory. If you can rotate the arm without changing the distance from pivot-center to spindle-center, that would work. But it is only an aesthetic issue! The outer edge of the plinth could be cut at any angle and this would not affect the turntable's function (e.g., the edges of the "box" could be cut to make a triangle, or a cirlce if that were aethetically sought).
Bdgregory, on the basic plus tonearm, there is a slot on the cylinder that only allow you to adjust the height, but one can not rotate it, so alignment to plinth can not be adjusted
on the basic plus tonearm, there is a slot on the cylinder that only allow you to adjust the height, but one can not rotate it, so alignment to plinth can not be adjusted
now I see . . . this is different than the Linn Ittok, and Audioquest PT6 I previously owned. With those it's very easy to create this alignment issue(which I have done when not paying attention). As noted, it's aesthetics, not function, so if there isn't an easy solution then leave it alone.