2. analog
  3. 1294607688

tonearm/cartridge matching, mass/damping/tweaking

I'm reading more and more, here and mostly elsewhere about matching cartrdge compliance to tonearm mass. Of course, the wonderful but also dreaded Denon 103/103r s are front in centre in most debates.
I recently swapped out my denon 103 for my nos GAS Sleeping Beauty and perceived a better overall sound although it just may be a better overall cart too, who knows?
I am running a Linn Akito 2b arm which is said to be a little low on the mass side for the Denon 103 at I think 11 grams. i have seen some raging debates with guys saying their black widow (really low mass) arm matches just great with a 103, and a mass proponent saying that you need at least 25 gram mass arm for the 103R (although his 'perfectly matched' jelco 750d is ironically an 18g mass arm....). being a sucker for punishment I have on order both a 301mkii and a 103r (my audiophile nervosa has ingrained me with the fear that 'they' may stop making cartridges - after all, I have read that the venerable technicss DD tables have been discontinued). Now, I could simply likely sell my Akito 2B and buy a Jelco 750db and be done with it. resurrect my light headshell for use with the 301 and start having swapping fun. WTF, I could prolly also build up an outboard tonearm stand and run a 12" jelco outside my SOTA opposite the akito2b and turn into a real freak (sorry to all you freaks out there, you know what you are ;-)).
I have read some possible arm tuning damping ideas too that dont smell of overdoing it. One being laying a couple of pieces of tonearm litz between the cart and the headshell when mounting to decouple slightly. Another is the adddition of herbie's hal-o jr's to the arm wand which is cheap maybe effective and readily reversible (unlike wrapping the wand).
i gotta wonder just how accurate some of these mass and compliance calcs are too. ironically, i had to use a supplied sheet of what appears to be lead with my GAS to give it sufficient weight to use with this arm and it is only a few grams less than the denon....
Any thoughts, ideas, current thinking on the mass vs compliance issues?
mickeyf

Showing 1 response by lewm

lewm
12,456 posts
 
"does adding 2 Herbie's dampers @ 5.65 grams each increase effective mass of the arm by 11.3 grams?"

I think the answer is yes, since the added mass will be situated essentially right above the stylus tip. If the added mass is displaced to the rear, toward the pivot, then the increase in "effective mass" will be related to the square of the distance between the stylus and the added mass. Formulae are somewhere on the internet. Try Vinyl Engine.
More to discover