2. analog
  3. 1121694267

SOTA table owners- getting upgraded

I have an older Star Sapphire version II which I bought new back in 1986 and subsequently upgraded with a III platter. In 1999 I put it into storage when moving to London and got it out earlier this year. I thought about getting a VPI Scout but ended up sending the table to SOTA to have the springs upgraded and while there, had the platter bearing replaced, the sub-chassis stiffened and dampened and purchased a Cosmos composite armboard. The motor, the original pabst, and the vacuum checked out fine.

I use the table with a SME V and a AT OC-9 cartridge. Man, what a difference these mods have made. Speed stability has improved as the hanging turntable no longer wobbles all over the place due no doubt to the new springs. The table's background noise is now so low that music comes out from a black and quiet background. Soundstaging and clarity have likewise seen substantial increases. If you have an older SOTA, I highly recommend these changes to your table.
barolobrain

Showing 3 responses by jhnovick2e19

jhnovick2e19
7 posts
 
Like you, I also have a Sota Sapphire MkII purchased in 1986. Recently, after having had it stored for 6 years, I set it up and have been astounded once again with what good analog sounds like.

I talked with Sota today about a couple of problems I am having. The service dept. is second to none. My only complaint is that they are no longer in Oakland, where I live!

They also recommended the upgrading of the springs to me. I am going to have it serviced locally because I dread packing and shipping the tt, but, I will have the techs check the spring system. I'm also suffering from a bit of hum coming somewhere from the tonearm/cartridge.

BTW, what kind of mat are you using?
jhnovick2e19
7 posts
 
In my own experience, and, in talking with Sota, that is not either recommended or good sounding to my ears. Even with their old rubber mat, the bass fullness, tightness, and, overall quality improves. I think the sound is too thin with a bare platter.
jhnovick2e19
7 posts
 
Sirspeedy. My table is not a vacuum model. Do you think this still applies? It is a Mk II table.
More to discover