Check the anti skate setting. If anti skate setting is too low, you will hear static in the right channel. Too high will give static in the left channel.
"Spitting" Cartridge problem
I've run into an issue I've never seen before and can't figure it out. I have an Ortofon Rondo Red mounted on an early TriPlanar on a Basis Ovation table. Recently the right channel has started making serious distortion on transients - it sounds like harsh static/spitting.
VTF, VTA, alignment are all good. And I haven't changed anything either - it just started happening out of the blue. The cart has maybe a few hundred hours on it. Could it just have gone bad?
It's not the phono pre, or anything else in the chain. I can't see how an interconnect could cause such an issue but it's captive so I can't change it easily.
VTF, VTA, alignment are all good. And I haven't changed anything either - it just started happening out of the blue. The cart has maybe a few hundred hours on it. Could it just have gone bad?
It's not the phono pre, or anything else in the chain. I can't see how an interconnect could cause such an issue but it's captive so I can't change it easily.