I contacted REL about this once and they said that they’ve done extensive testing on their units and did not find any real, hearable differences as long as the proper (minimum) gauge wire is used.
Power cable choice, does it matter for subs?
Should replacing the PC on a subwoofer make a difference you could notice?
I just discovered I had accidentally installed an18ga cord on one of my subs. It was the most power hungry of the bunch and I feel bad about starving it. I did install a stock type 14ga I found in house and it did seem to tighten it up a bit but that could be my imagination.
In your experience, any thoughts on if going to a better/higher gauge cord on subs would or should make much difference?
Thanks,
RW
I just discovered I had accidentally installed an18ga cord on one of my subs. It was the most power hungry of the bunch and I feel bad about starving it. I did install a stock type 14ga I found in house and it did seem to tighten it up a bit but that could be my imagination.
In your experience, any thoughts on if going to a better/higher gauge cord on subs would or should make much difference?
Thanks,
RW