2. analog
  3. 1111970502

Oracle Alexandria - time for new springs?

Hi,

I recently went through and readjusted the suspension on my Oracle Alexandria turntable according to the manual. When set up "properly," two of the three spring covers no longer fit into place as the springs are protruding too far above the deck. Everything sounds fine but this thing with the spring covers is a real drag. I bought the table used and it came with the Sumiko MMT tonearm and [ugly] head shell. I am using an older Sumiko Blue Point cartridge. I am wondering if this is a sign that the springs are bad and need to be replaced. I've always assumed that it has the correct type of springs since the tonearm is standard; maybe not. Anyone have any experience with, or ideas about, such suspension table problems?

Thanks,
rickk

Showing 2 responses by newbee

newbee
4,751 posts
 
How far off of the plinth is the bottom of the TT platter? Is it the distance spec'ed out in the manual? I've never had this problem and really can't imagine how it would occur.
newbee
4,751 posts
 
My platter is also 1/4" above the plinth. I've no problem fitting the caps over the springs. Perhaps you do need new springs, however before your go that route you might try lowering the platter to 1/8th inch. So long as the platter is operating perfectly level and that space is even around the platter I don't think this height issue is that critical. Worth a try.

Regarding the tone arm. My Oracle came with the Oracle arm - nice arm but a PITA - I changed it to a MMT. I did not change the spring(s) and it has worked fine, however I've always felt, subjectively, that the spring on the arm side could have been a bit stiffer. When you press down on the platter and release it, it doesn't move up and down in a perfectly vertical motion. But in practice it didn't really make a sonic difference, to my ear anyway.

Wish I could have been of more help........
More to discover